Nissan Sentra B18 (2020-2025) Service Manual: REMOVAL
Remove rear bumper fascia. Refer to Removal and Installation.
Disconnect the harness connector
(A) from the rear sonar sensor inner (1). 
|
|
:Pawl |
Using a suitable tool, release pawls from the rear sonar sensor inner and remove.
Remove the rear sonar sensor finisher from the bumper fascia (if necessary).
INSTALLATION
CAUTION:
Verify that the connector direction is within the
specification shown when assembling the bumper fascia.
(A)
...
Other materials:
Clutch piping
Exploded View
CSC (Concentric Slave Cylinder)
Clip
Clutch tube
Clutch damper
Bracket
Clutch master cylinder
Hydraulic Layout
Clutch tube
Lock pin
CSC (Concentric Slave Cylinder)
Clutch damper
Clutch master cylinder
Clutch pedal
Removal and Installation
CAU ...
Right/left Switching Signal Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Check the terminals and connectors of
the side radar RH for damage, bend and short (unit
side and connector side).
...
Engine Coolant
Inspection
Inspection
Warning:
Do not remove the radiator cap or reservoir tank
cap when the engine is hot. Serious burns could occur from
high-pressure engine coolant escaping from the cooling
system.
When removing the ...