CAUTION:

Verify that the connector direction is within the specification shown when assembling the bumper fascia.

Install rear sonar sensor inner to sensor finisher.

Degrease and clean the inner side of the rear bumper fascia and apply adhesion promoter to the area shown (A).

Let the adhesion promoter dry for more than three minutes and peel off the double sided tape film, and then taking precautions not to contact the bumper with the double sided tape (A), bend the rear sonar sensor inner finisher in the direction shown.

Match the part of the rear sonar sensor inner (A) shown in the figure to the sensor installing hole of the rear bumper fascia.

Remove the rear sonar sensor inner from the sensor finisher and press the adhesion face (A) for more than two seconds to securely bond the rear sonar sensor inner finisher to rear bumper fascia inner.

CAUTION:

• When temperature is less than 15°C (59°F), use a drier, etc., to warm the adhesion face and proceed.

• After installing front sonar sensor inner finisher, do not move finisher for two - three hours.

Install rear sonar sensor inner to the sensor finisher.

Shake the part of the rear sonar sensor inner finisher (A) up and down and then right and left to confirm that the finisher has been installed (bonded) firmly.

Connect the harness connector to the rear sonar sensor inner.

Install rear bumper fascia. Refer to Removal and Installation.

REAR SONAR SENSOR OUTER