Nissan Sentra B18 (2020-2025) Service Manual: Rear Seat Belt Pre-Tensioner. Removal and Installation
Removal and Installation
Removal and Installation
Warning:
-
Before servicing the SRS, place the ignition switch in the OFF position, disconnect both battery terminals then wait at least three minutes.
-
Do not use air tools or electric tools for servicing the rear seat belt retractor.
-
Do not drop the seat belt retractor. Always handle it with care.
-
Always point pre-tensioner cylinder away from body when handling.
The rear seat belt pre-tensioner is serviced as part of the rear seat belt retractor. For removal and installation of the rear seat belt retractor, refer to Removal and Installation.
Other materials:
C1734-16 Tire Pressure Sensor Rr
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure rep ...
Dtc Inspection Priority Chart
DTC Inspection
Priority Chart
If some DTCs are displayed at the same time, perform
inspections one by one based on the following priority chart:
Priority
DTC
...
Heater & Air Conditioning System. Service Data and Specifications (sds). Service Data and Specifications (sds). Service Data and Specification (sds)
Service Data and Specifications (sds). Service Data and Specification (sds)
Service Data and Specification (sds)
Service Data and Specification (SDS)
COMPRESSOR
Model
Sanden
...