Inspection

Inspection

APPEARANCE

Check the surface of the disc brake rotor for uneven wear, cracks, or damage. Replace the disc brake rotor if any abnormal conditions exist. Refer to Removal and Installation.

RUNOUT

Check the wheel bearing axial end play before the inspection. Refer to Inspection.

Secure the disc brake rotor to the wheel hub with wheel nuts at two wheel nut locations.

Measure the runout using a dial indicator to 10 mm (0.39 in) from the disc brake rotor edge.

Find the installation position with the minimum runout by shifting the disc brake rotor-to-wheel hub installation position by one hole at a time if the runout exceeds the limit value.

Refinish the disc brake rotor if the runout is outside the limit even after performing the above operation. When refinishing, use Tool.

CAUTION:

• Check in advance that the thickness of the disc brake rotor is wear thickness + 0.3 mm (0.012 in) or more.

• If the thickness is less than wear thickness + 0.3 mm (0.012 in), replace the disc brake rotor. Refer to Removal and Installation.

THICKNESS

Check the thickness of the disc brake rotor using a micrometer. Replace the disc brake rotor if the thickness is below the wear limit. Refer to Removal and Installation.