Precautions for Supplemental Restraint System (srs) Air Bag and Seat Belt Pre-Tensioner : Precautions
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collisions.
Information necessary to service the system safely is included in the “SRS AIR BAG” and “SEAT BELT” sections of this Service Manual.
Warning:
Always observe the following items for preventing accidental activation:
To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision that would result in air bag inflation, it is recommended that all maintenance and repair be performed by an authorized NISSAN/INFINITI dealer.
Improper repair, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see “SRS AIR BAG”.
Never use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS
Warning:
Always observe the following items for preventing accidental activation:
When working near the Air Bag Diagnosis Sensor Unit or other Air Bag System sensors with the ignition/power switch ON or engine running, never use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the ignition/power switch OFF, disconnect the 12V battery or batteries, and wait at least 3 minutes before performing any service.
Precautions for Feb System Service
CAUTION:
Never use the distance sensor removed from vehicle. Never disassemble or remodel.
Erase DTC when replacing parts of AEB system. Then check the operation of AEB system after radar alignment if necessary.
Never change AEB system state ON/OFF without the consent of the customer.
Turn the AEB system OFF in conditions similar to driving, such as free rollers or a chassis dynamometer.
PRECAUTION FOR DISTANCE SENSOR
Never use the distance sensor removed from Nissan Sentra vehicle. Never disassemble or remodel.
Never install a part that the radar irradiation range is interfered with.
If a part interferes with the radar irradiation range, then the following conditions are caused:
The condition of distance sensor becomes equal to an unclean condition, and this makes it difficult to measure the distance between cars.
When it is impossible to measure the distance between cars, the AEB function stop and DTC is detected.
PrecautionPower supply and ground circuit
Combination meter
Combination meter : diagnosis procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check fuses
Check that the following fuses are not blown.
Is the fuse blown?
YES >> Replace the blown fuse after repairing the affected circu ...
Component Inspection
Component Inspection
CHECK POWER WINDOW RELAY
Ignition switch OFF.
Remove power window relay.
Check continuity between power window relay terminals.
...
The steering switch (meter control switch) is inoperative
Description
If any of the following malfunctions is found for the steering switch (meter
control switch) operation.
All switches are inoperative
The specified switch cannot be operated
Diagnosis procedure
1.Check steering switch signal circuit
Check the steering switch signal circuit. ...