Nissan Sentra Service Manual: Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the sr and sb section of this service manual.
Warning:
- To avoid rendering the srs inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized nissan/infiniti dealer.
- Improper maintenance, including incorrect removal and installation of the srs, can lead to personal injury caused by unintentional activation of the system. For removal of spiral cable and air bag module, see the sr section.
- Do not use electrical test equipment on any circuit related to the srs unless instructed to in this service manual. Srs wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.
Precautions when using power tools (air or electric) and hammers
Warning:
- When working near the airbag diagnosis sensor unit or other airbag system sensors with the ignition on or engine running, do not use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
- When using air or electric power tools or hammers, always switch the ignition off, disconnect the battery and wait at least three minutes before performing any service.
Eco mode (cvt)
...
System description
Component parts
Component parts location
Instrument lower finisher
Component description
Eco mode switch
The ECO mode switch is installed to the instrument lower finisher.
When ...
Other materials:
Compass display (if so equipped)
This unit measures terrestrial magnetism and indicates
heading direction of vehicle.
With the ignition switch in the ON position, press
the button as described in the
chart below
to activate various features of the automatic antiglare
rearview mirror.
For more information about the au ...
Repairing material
Foam Repair
During factory assembly, foam insulators are installed in certain body panels
and locations around the vehicle.
Use the following procedure(s) to replace any factory-installed foam insulators.
URETHANE FOAM APPLICATIONS
Use commercially available Urethane foam for sealant (foam m ...
Glove box assembly
Removal and Installation
REMOVAL
Remove the instrument side finisher RH using a suitable tool.
Remove the glove box assembly upper screws (A).
Remove the glove box assembly lower screws (A).
Disconnect the harness connectors from the trunk switch and glove box
lamp, the ...
