Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Power Window and Door Lock/unlock Switch Rh

Diagnosis Procedure

Diagnosis Procedure
  1. CHECK FUSE

      1. Ignition switch OFF.

      2. Check that the following fuse is not blown (open):

        Signal name

        Fuse No.

        Capacity

        Ignition power supply

        52

        20 A

    Is the fuse blown (open)?

    YES>>

    Repair the blown (open) fuse after repairing the affected circuit if a fuse is blown (open).

    NO>>

    GO TO 2.

  2. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH POWER SUPPLY

      1. Disconnect power window and door lock/unlock switch RH connector.

      2. Ignition switch ON.

      3. Check voltage between power window and door lock/unlock switch RH harness connector and ground.

      (+)

      (–)

      Voltage

      (Approx.)

      Power window and door lock/unlock switch RH

      Connector

      Terminal

      D104

      8

      Ground

      Battery voltage

    Is the inspection result normal?

    YES >>

    GO TO 3.

    NO >>

    Repair or replace harness.

  3. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH GROUND

      1. Ignition switch OFF.

      2. Check continuity between power window and door lock/unlock switch RH harness connector and ground.

      (+)

      (–)

      Continuity

      Power window and door lock/unlock switch RH

      Connector

      Terminal

      D104

      3

      Ground

      Yes

    Is the inspection result normal?

    YES >>

    Inspection End.

    NO >>

    Repair or replace harness.

Main Power Window and Door Lock/unlock Switch
Diagnosis Procedure Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that any of ...

Rear Power Window Switch
Diagnosis Procedure Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the fo ...

Other materials:

Moonroof (if so equipped)
Power moonroof The moonroof will only operate when the ignition switch is placed in the ON position. The power moonroof is operational for a period of time, even if the ignition switch is placed in the ACC or OFF position. If the driver’s door or the front passenger’s door is opened du ...

Front power window motor
Removal and Installation REMOVAL Remove the front door glass regulator (2). Refer to GW-16, "Removal and Installation". Remove the bolts (A) and the front power window motor (1). INSTALLATION Installation is in the reverse order of removal. ...

Continuously Variable Transmission (CVT) (if so equipped)
WARNING Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive) or L (Low). Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an accident. Col ...

© 2014-2026 Copyright www.nisentra.com