Nissan Sentra Service Manual: Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
- Release the pawls using a suitable tool and lift the power window and door lock/unlock switch RH and finisher as an assembly and remove.
- Disconnect the harness connector from the power window and door lock/unlock switch RH.
- Release the four pawls (two on each side) using a suitable tool, then separate the main power window and door lock/unlock switch RH (1) from the main power window and door lock switch RH finisher (2).
: Pawl
CAUTION:
Do not bend back the pawls on the switch finisher too far or breakage may occur.
INSTALLATION
Installation is in the reverse order of removal.
Main power window and door lock/ unlock switch
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the main power window
and door lock/unlock switch and
finisher as an assembly and remove.
Disconnect the h ...
Rear power window switch
Removal and Installation
REMOVAL
Release the pawls using a suitable tool and lift the rear power window
switch and finisher as an assembly
and remove
Disconnect the harness connector from ...
Other materials:
Differential side oil seal
Exploded View
Transaxle assembly
Differential side oil seal (left side)
Differential side oil seal (right side)
: Vehicle front
: Always replace after every
disassembly.
: Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
NOTE:
Cap or plug openings to prevent f ...
Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
Start the engine.
Shift selector lever.
Check that the selector lever position and the shift position indicator
on the combination meter are identical.
Is the inspection result normal?
YES >> INSPECTION END
N ...
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
