Nissan Sentra B18 (2020-2025) Service Manual: Power Supply and Ground Circuit
Diagnosis Procedure
Diagnosis Procedure
-
CHECK FUSE
-
Check that the following fuses are not blown:
Terminal No.
Signal name
Fuse No.
Capacity
1
Battery power supply
35
10 A
10
Ignition signal
48
10 A
Are the fuses blown?
YES >>Replace the blown fuse after repairing the affected circuit.
NO >>GO TO 2.
-
-
CHECK POWER SUPPLY CIRCUIT
-
-
Ignition switch OFF.
-
Disconnect TCU connector .
-
Check voltage between TCU connector and ground.
(+)
(-)
Condition
Voltage
(Approx.)
TCU
Connector
Terminal
M160
1
Ground
Ignition switch: OFF
Battery voltage
10
Ignition switch: ON
-
Is the inspection result normal?
YES >>GO TO 3.
NO >>Repair or replace harness or connectors.
-
-
CHECK GROUND CIRCUIT
-
-
Ignition switch OFF.
-
Check continuity between TCU connector and ground.
TCU
—
Continuity
Connector
Terminal
M160
28
Ground
Yes
29
-
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
-
Other materials:
P0117 Ect Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Icc System Cannot Be Set (main Switch Turns On/off)
Diagnosis Procedure
Diagnosis Procedure
The ICC MAIN switch can be turned ON/OFF, but the ICC system
cannot be set even if the SET- switch is pressed.
Note:
The system cannot be set in the following case.
When own Nissan Sentra vehicle is travelling below the speed of
...
Precaution. Precautions
Precautions
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG� and “SEAT BELT PRE-TENSIONER�,
u ...