Nissan Sentra B18 (2020-2025) Service Manual: Power Seat Switch
Removal and Installation
REMOVAL
Remove the front seat. Removal and Installation .
Using a
suitable tool (A) remove seat recline knob (1) and seat slide knob
(2). 
Using a
suitable tool release pawls, then pull to release metal
clips. 
|
|
: Pawl |
|
|
: Metal clip |
Disconnect the harness connectors from the power seat switch.
Remove
screws (A) and the power seat switch (1). 
INSTALLATION
Installation is in the reverse order of removal.
Heated Seat Switch
Removal and Installation
Removal and Installation
REMOVAL
The front heated seat switch is part of A/C
switch assembly.
If replacing the front heated seat switch,
replace the A/C switc ...
Lumbar Support Switch
Removal and Installation
Removal and Installation
REMOVAL
Remove the
front seat. Removal and Installation .
Using a
suitable tool release pawls, then pull to release metal
clip ...
Other materials:
Symptom diagnosis
The sport mode indicator lamp does not turn on
Description
The sport mode indicator lamp does not turn on when the sport mode switch is
operated.
Diagnosis procedure
1.Perform combination meter on board diagnosis
Perform combination meter on board diagnosis. Refer to mwi-16, "descriptio ...
Power supply and ground circuit
Combination meter
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check fuses
Check that the following fuses are not blown.
Is the fuse blown?
Yes >> replace the blown fuse after repairing the affected circu ...
Disposal
Disposal
Set the
strut horizontally with the piston rod fully extended.
Drill a 2
– 3 mm (0.08 – 0.12 in) hole at the position ()
from top as shown to release gas gradually.
CAUTION:
Wear eye protection (safety glasses).
Wear ...
