Nissan Sentra B18 (2020-2025) Service Manual: Disposal
Set the strut horizontally with the piston rod fully extended.
Drill a 2
– 3 mm (0.08 – 0.12 in) hole at the position (
)
from top as shown to release gas gradually. 
CAUTION:
-
Wear eye protection (safety glasses).
-
Wear gloves.
-
Be careful with metal chips or oil blown out by the compressed gas.
-
Drill vertically in this direction (
)
directly to the outer tube avoiding brackets. -
The gas is clear, colorless, odorless, and harmless.
|
(A) |
: 20 – 30 mm (0.79 – 1.18 in) |
Position the drilled hole downward and drain oil by moving the piston rod several times.
CAUTION:
Dispose of drained oil according to the law and local regulations.
Inspection
Inspection
INSPECTION AFTER DISASSEMBLY
Check the following items and replace the parts
if necessary.
Strut
Check the strut for oil leaks, deformation,
cracks, or damag ...
Other materials:
P2018 Intake Manifold Runner Control Valve Position Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Illumination control switch
Removal and installation
Removal
Remove instrument finisher d. Refer to ip-14, "exploded view".
Remove the illumination control switch (1) from the switch carrier
(2) using suitable tool (a).
: Pawl
Installation
Installation is in the reverse order of removal. ...
Removal and Installation
Removal and Installation
REMOVAL
Remove rear
seatback. Refer to Removal and Installation.
Remove
LATCH bracket bolts and remove LATCH bracket.
INSTALLATION
Install and
tighten LATCH bracket bolts to specification in the sequence
shown:
...
