Nissan Sentra Service Manual: Periodic maintenance
In-cabin microfilter
Exploded View
Removal and Installation
REMOVAL
- Remove the in-cabin microfilter cover.
CAUTION:
Before removing the in-cabin micofilter cover, let the vehicle rest for at least 30 minutes.
- Release the filter cover tab (A), then pull the bottom of the in-cabin microfilter cover outwards.
- Pull down the in-cabin microfilter cover to disengage the hook at the top, then remove the in-cabin microfilter cover.
- Remove the in-cabin microfilter.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation, check that the in-cabin microfilter cover is securely fastened to the heating and cooling unit assembly.
Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Commercial Service Tool
...
System description
In-cabin microfilter
Description
FUNCTION
Air inside the passenger compartment is kept clean at either recirculation
or fresh mode by installing an in-cabin microfilter into the heating
and cooli ...
Other materials:
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Front wiper motor ground circuit
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With
Intelligent Key" or WW-29,
"Wiring Diagram - Without Intelligent Key".
1.Check front wiper motor (gnd) open circuit
Turn the ignition switch OFF.
Disconnect front wiper mot ...
Radio
With the ignition placed in the ACC or ON position,
press the PWR (power)/VOL (volume) knob
to turn the radio on. If you listen to the radio with
the engine not running, the ignition should be
placed in the ACC position.
Radio reception is affected by station signal
strength, distance from r ...
