Removal and Installation
REMOVAL
Set the parking brake pedal in the completely released position.
Disconnect the harness connector from the parking brake switch.
Remove the screw and the parking brake switch. Refer to Exploded View.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Replace the parking brake switch if it has been dropped or sustained an impact.
Parking Brake Rear CableConfirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
at least 10 seconds before conducting the next test.
>&g ...
Installing top tether strap
WARNINGChild restraint anchorages are designed
to withstand only those loads imposed by
correctly fitted child restraints. Under no
circumstances are they to be used to attach
adult seat belts, or other items or
equipment to the vehicle. Doing so could
damage the child r ...
Low Tire Pressure Warning
System Description
System Description
SYSTEM DIAGRAM
INPUT SIGNAL AND OUTPUT SIGNAL
Major signal transmission between each unit via
communication is shown in the following table:
Component parts
Sig ...