Nissan Sentra B18 (2020-2025) Service Manual: Operation

Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Type B / System Description / Operation

Switch Name and Function

Switch Name and Function

STEERING SWITCH

The steering switch is located on the steering wheel.
Transmits the steering switch signal to the combination meter.

No.	Switch name	Operation	Description
1.	OK/Up/Down/Left/Right switch	Press	The information display settings can be changed.
2.	Back switch	Press	The information display settings can be changed.

TRIP RESET SWITCH

The trip reset switch is located on the instrument lower panel LH.
Transmits the trip reset switch signal to the combination meter.

No.	Switch name	Operation	Description
1.	Trip reset switch	Press	The trip meter can be switched between A and B. Trip meter A/B can be reset by pressing and holding the trip reset switch. A trip computer value displayed on the information display can be reset by pressing and holding the trip reset switch for 1 second or more. All trip computer values can be reset by pressing and holding the trip reset switch for 3 seconds or more.

ILLUMINATION CONTROL SWITCH

The illumination control switch is located on the instrument lower panel LH.
Transmits the following signals to the combination meter:
- Illumination control switch signal (+)
- Illumination control switch signal (−)

No.	Switch name	Operation	Description
1.	Illumination control switch (−)	Press	The brightness of combination meter and information display can be adjusted.
2.	Illumination control switch (+)	Press

System

Meter System System Description System Description SYSTEM DIAGRAM Combination Meter Input Signal (CAN Communication Signal) ...

Diagnosis System (combination Meter)

On Board Diagnosis Function On Board Diagnosis Function ON BOARD DIAGNOSIS The following meter functions can be checked during Combination Meter Self-Diagnosis Mode: Pointer s ...

Other materials:

Wheel Side
Removal and Installation Removal and Installation REMOVAL Remove disc brake rotor. Refer to Removal and Installation. CAUTION: Do not depress the brake pedal while the brake caliper is removed. Remove the wheel sensor bolt. Position the wheel sensor and the ...

Removal and Installation
Removal and Installation REMOVAL Warning: Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes. Do not use air tools or electric tools for servicing. ...

ECU diagnosis information
A/C AUTO AMP Reference Value TERMINAL LAYOUT PHYSICAL VALUES *:With manual A/C ECM, IPDM E/R, BCM List of ECU Reference ...