Nissan Sentra Owners Manual: Manual control
While using the voice recognition system, it is possible to select menu options by using the steering wheel controls instead of speaking voice commands. This can be especially helpful if the noise of driving makes it difficult for the voice recognition system to accurately interpret commands.
The manual control mode does not allow
dialing a phone number by digits. The user may
select an entry from the Phonebook or Recent
Calls lists. To re-activate voice recognition, exit
the manual control mode by pressing and holding
the PHONE/END ( 
) button. At that
time,
pressing the PHONE/SEND ( 
) button
will
start the Hands Free Phone System.
Operating tips
- To enter manual control mode, start the
voice recognition system and tilt the tuning
(
) switch up or down. The
system will speak Showing Manual Options when manual controls are initially activated. - To browse the menu options, tilt the tuning
(
) switch up or down. The
system will always speak the current menu option. Depending on the audio display, it will also show the current menu option. - To select the current menu option, press the
PHONE/SEND (
) button. - To go back to the previous menu, press the
PHONE/END (
) button. If the
current menu is the Main Menu, pressing the PHONE/END (
) button will exit
the Phone system. - To exit the manual control mode, press and
hold the PHONE/END (
) button
for 5 seconds
Voice Adaptation (VA) mode
Voice Adaptation allows up to two out-of-dialect
users to train the system to improve recognition
accuracy. By repeating a number of commands,
the users can create a voice model of their own
voice ...
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
try the following solutions.
Where the solutions are listed by number, try
each solutio ...
Other materials:
Removal and installation
Hood
Hood assembly
Hood assembly : exploded view
Hood hinge (LH/RH)
Hood assembly
Hood bumper rubber
Hood seal
Hood insulator
Hood support rod
Hood support rod clamp
Clip
Hood assembly : removal and installation
CAUTION:
Use two people when removing or installing h ...
Basic inspection
Diagnosis and repair work flow
Work flow
Detailed flow
1.Obtain information about symptom
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurs.
>> GO TO 2.
2.Check symptom
Check the symptom based ...
Cluster lid C
Removal and Installation - Cluster Lid C
REMOVAL
Remove cluster lid C lower. Refer to IP-20, "Removal and Installation -
Cluster Lid C Lower".
Remove the cluster lid C screws (A).
Disconnect the harness connector from cluster lid C.
Remove the center ventilator grill ...
