Nissan Sentra B18 (2020-2025) Service Manual: INSTALLATION
CAUTION:
Verify that the connector direction is within the specification shown when assembling the bumper fascia.
|
(A) |
: Horizontal position |
|
(a) |
: ±10° |
Install sonar sensor outer to sensor cover.
Degrease and clean the inner side
of the rear bumper fascia and apply adhesion promoter to the area
shown (A). 
Let the adhesion promoter dry for
more than 3 minutes and peel off the double sided tape film, and then
taking precautions not to contact the bumper with the double sided
tape (A), bend the sensor cover in the direction shown. 
Match the part of the sonar sensor
(A) shown in the figure to the sensor installing hole of the rear
bumper fascia. 
Remove the sensor from the sensor
cover and press the adhesion face (A) for more than 2 seconds to securely
bond the sensor cover to rear bumper fascia inner. 
|
Target pressure |
: 50.0 N (5.1 kg,) |
CAUTION:
-
When temperature is less than 15 C (59 F), use a drier, etc., to warm the adhesion face and proceed.
-
After installing sensor cover, do not move cover for 2–3 hours.
Install sensor to the sensor cover.
Shake the part of the sensor cover
(A) up and down and then right and left to confirm that the cover
has been installed (bonded) firmly. 
Connect the harness connector to the sonar sensor outer.
REMOVAL
Release the rear sonar sensor cover
(1) pawls using suitable tool and remove the rear sonar sensor outer
(2).
...
Sonar Buzzer
...
Other materials:
Diagnosis Procedure
Diagnosis Procedure
CHECK EPS WARNING LAMP
Perform the trouble diagnosis of EPS warning
lamp. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>
Check that there is no malfunction in each
...
Frequently Cannot Detect the Vehicle Ahead / Detection Zone Is Short
Diagnosis Procedure
Diagnosis Procedure
The detection function may become unstable in the following
cases.
When radar reflections from the Nissan Sentra vehicle ahead is
interrupted.
When driving a road with extremely sharp corners.
When ...
Removal and Installation
Removal and Installation
CAUTION:
Do not reuse CSC (Concentric Slave Cylinder). The
CSC slides back to the original position every time the transaxle
assembly is removed. This action may allow dust or contaminants to
gather on the sliding parts ...
