Nissan Sentra B18 (2020-2025) Service Manual: Removal and Installation
CAUTION:
-
Do not reuse CSC (Concentric Slave Cylinder). The CSC slides back to the original position every time the transaxle assembly is removed. This action may allow dust or contaminants to gather on the sliding parts and damage a seal of CSC causing clutch fluid leakage.
-
Do not disassemble CSC.
-
Keep painted surface on the body or other parts free of clutch fluid. If clutch fluid spills, wipe up immediately and wash the affected area with water.
REMOVAL
Remove engine and transaxle assembly. Refer to Removal and Installation.
Remove CSC bolts, then remove the CSC from transaxle assembly.
INSTALLATION
Install CSC to transaxle assembly, then tighten CSC bolts to the specified torque.
CAUTION:
-
Do not reuse CSC.
-
Do not install then operate CSC immediately, the piston and stopper of CSC components may fall off.
Install engine and transaxle assembly in the reverse order of removal. Refer to Removal and Installation.
Exploded View
Exploded View
1.
Transaxle assembly
2.
...
Inspection and Adjustment
Inspection and Adjustment
INSPECTION AFTER INSTALLATION
Check for fluid leakage and the fluid level.
Refer Inspection.
ADJUSTMENT AFTER INSTALLATION
Perform the
air bleeding. Refer to ...
Other materials:
P0845-00 Transmission Fluid Pressure Sensor/switch a
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
conditi ...
Condenser
Exploded view
Core support upper cover
High-pressure pipe
High-pressure flexible hose
Refrigerant pressure sensor
Condenser and liquid tank assembly
Core support upper
Front
Condenser
Condenser : removal and installation
REMOVAL
Discharge the refrigerant. Refer to HA-23, & ...
Diagnosis Procedure
Diagnosis Procedure
REPLACE A/C SWITCH ASSEMBLY
Ignition switch OFF.
Replace A/C switch assembly (rear window defogger
switch). Refer to Removal and Installation (with automati ...
