Nissan Sentra manuals

Toyota Camry Owner's Manual (2023): Inside rear view mirror

The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view.

Adjusting the height of rear view mirror

The height of the rear view mirror can be adjusted to suit your driving posture.

Adjust the height of the rear view mirror by moving it up and down.

Adjusting the steering wheel and mirrors

Anti-glare function

Manual anti-glare inside rear view mirror

Reflected light from the headlights of vehicles behind can be reduced by operating the lever.

  1. Normal position
  2. Anti-glare position

Adjusting the steering wheel and mirrors

Auto anti-glare inside rear view mirror

Responding to the level of brightness of the headlights of vehicles behind, the reflected light is automatically reduced.

Changing automatic anti-glare function mode

On/off

When the automatic anti-glare function is in ON mode, the indicator illuminates.

The function will set to ON mode each time the engine switch is turned to IGNITION ON mode.

Pressing the button turns the function to OFF mode. (The indicator also turns off.)

Adjusting the steering wheel and mirrors

■To prevent sensor error (vehicles with an auto anti-glare inside rear view mirror)

To ensure that the sensors operate properly, do not touch or cover them.

Adjusting the steering wheel and mirrors

WARNING

Do not adjust the position of the mirror while driving.

Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.

Steering wheel
Adjustment procedure 1. Hold the steering wheel and push the lever down. 2. Adjust to the ideal position by moving the steering wheel horizontally and vertically. After adjustment, pull the ...

Outside rear view mirrors
Adjustment procedure 1. To select a mirror to adjust, turn the switch. Left Right 2. To adjust the mirror, operate the switch. Up Right Down Left Folding the mirrors Push ...

Other materials:

Diagnosis system (ipdm e/r) (without intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test, the IPDM E/R sends a drive signal to the following systems to check their operation. Front wiper (LO, HI) Parking lamp License plate lamp Tail lamp Front fog lamp (if equipped) Headlamp (LO, HI) A/C compres ...

Replacement operations
Description This section is prepared for technicians who have attained a high level of skill and experience in repairing collision- damaged vehicles and also use modern service tools and equipment. Persons unfamiliar with body repair techniques should not attempt to repair collision-damaged v ...

P1212 TCS Communication line
Description This CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and “ABS actuator and electric unit (control unit)”. Be sure to erase the malfunction information such as DTC not only for †...

© 2014-2022 Copyright www.nisentra.com