Diagnosis Procedure

Diagnosis Procedure

Check the idle start/stop system operation condition. Refer to System Description.

1. CHECK START/STOP PROHIBIT CAUSE

   With CONSULT

   Select “Stop/Start prohibit cause data recorder” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.

   Does "Stop/Start prohibit cause data recorder" show fail-safe?

   YES >>

   GO TO 2.

   NO >>

   Check the operating status of system start/stop. Refer to System Description. After confirmation, 4.

2. CHECK "Stop/Start error" OF CONSULT DATA MONITOR ITEM

   With CONSULT

   1. Select "Stop/Start error" in "Monitor Menu" of "DATA MONITOR" mode in CONSULT.

   2. Check the displayed data monitor items. Refer to Diagnosis Description.

   Are there any "NG" monitor items?

   YES >>

   After confirming the "NG" item, GO TO 3.

   NO >>

   GO TO 3.

3. CHECK DTC

   With CONSULT

   Perform “All DTC Reading” with CONSULT.

   Does it detect the DTC associated with "Stop/Start error" of "DATA MONITOR"?

   YES >>

   Perform trouble diagnosis of detected DTC. After repairing the defective part, 4.

   NO >>

   GO TO 4.

4. CHECK START/STOP INDICATOR / LAMP

   Check the start/stop indicator / lamp.

   WARNING LAMP/INDICATOR LAMP / INDICATOR	CONDITION
   Start/Stop indicator / lamp	Not blinking

   Is the start/stop indicator / lamp blinking?

   YES >>

   Refer to Symptom Table.

   NO >>

   INSPECTION END