Information
“CAN” of LAN Section describes information peculiar to a vehicle and inspection procedures.
For trouble diagnosis procedure, refer to Trouble Diagnosis Flow Chart of “CAN FUNDAMENTAL”.
Abbreviation List
Unit name abbreviations in CONSULT CAN diagnosis and in this section are as per the following list.
|
Abbreviation |
Unit name |
|---|---|
|
8ch CGW |
8CH CAN gateway |
|
A-AMP. |
BOSE speaker amp. |
|
A-BAG |
Air bag diagnosis sensor unit |
|
ABS |
ABS actuator and electric unit (control unit) |
|
AV |
AV control unit |
|
AVM |
Around view monitor control unit |
|
BCM |
BCM |
|
CCM |
Chassis control module (with built in steering angle sensor) |
|
DLC |
Data link connector |
|
ECM |
ECM |
|
EPS/DAST 3 |
EPS control unit |
|
EVTC |
Electric intake valve timing control module |
|
HFM |
Intelligent Key unit |
|
HVAC |
A/C auto amp. |
|
A/C amp. |
|
|
ICC 2 |
ADAS control unit 2 |
|
IPDM-E |
IPDM E/R |
|
IVC |
TCU |
|
LANE |
Front camera unit |
|
LASER |
Distance sensor |
|
M&A |
Combination meter |
|
RDR-L |
Side radar LH |
|
RDR-R |
Side radar RH |
|
SONAR |
Sonar control unit |
|
TCM |
TCM |
PrecautionExploded View
Exploded View
1.
Door glass rubber
run
2.
Front door glass
front run
3.
...
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS ...
Description
NOTE:
This vehicle is diagnosed using the CONSULT-III plus.
When CONSULT is connected with a data link connector
equipped on the vehicle side, it will communicate with the control
unit equipped in the vehicle and then enable various kinds of diagnostic
tests.
Instrument lower panel LH ...