Nissan Sentra Service Manual: Horn

Condenser

Removal and installation Removal Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER : Removal and Installation". Disconnect the harness connectors (1), remove ...

Precaution

Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The supplemental restraint system such as “air bag” and “seat belt pre- ...

Other materials:

Power supply and ground circuit
Combination meter COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram". 1.Check fuses Check that the following fuses are not blown. Is the fuse blown? Yes >> replace the blown fuse after repairing the affected circu ...

Controls
Fan control dial The fan control dial turns the fan on and off, and controls fan speed. Air flow control buttons The air flow control buttons allow you to select the air flow outlets. MAX — Air flows from center and side A/Cvents with maximum cooling. — Air flows from center and side v ...

Abs branch line circuit
Diagnosis procedure 1.CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ABS actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...