
1. Pull the hood lock release handle 1, located on the lower driver-side door pillar, until the hood lifts slightly.
2. Move to the front of the Nissan Sentra and locate the secondary safety lever 2 positioned between the hood and the grille. Push the lever sideways using your fingertips.
3. Carefully raise the hood 3.
4. Remove the support rod 4 and securely insert it into the designated slot marked by an arrow to hold the hood open.
NOTE:
Always place the support rod only in the specified slot. Incorrect placement may cause the hood to fall unexpectedly.
When handling the support rod, hold the coated sections only. Avoid touching the bare metal areas, as they may be hot immediately after the engine has been turned off.
To close the hood, return the support rod to its original retaining position. Lower the hood to approximately 12 in (30 cm) above the latch, then release it to allow proper engagement of the hood latch mechanism.
WARNING
Remote Engine Start
Trunk lidPrecaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along with a front seat belt, helps to reduce the risk or
severity of injury to the driver and fron ...
System
VDC/TCS/ABS
VDC/TCS/ABS : System Diagram
VDC/TCS/ABS : System Description
The system switches fluid pressure of each brake caliper and
each wheel cylinder to increase, to hold, or to
decrease according to signals from control unit in ABS actuator and electric
unit (control unit) ...
U2118 Can Comm Circuit
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...