Nissan Sentra B18 (2020-2025) Service Manual: Front Axle :: Preparation. Preparation
Preparation. Special Service Tool
Special Service Tool
|
Tool number (TechMate No.) Tool name |
Description |
|
|---|---|---|
|
KV40107300 (NI-51751) Boot band crimping tool |
 |
Installing boot band |
|
ST33710000 ( — ) Drift |
 |
Removing wheel hub a: 30 mm (1.18 in) dia. b: 23 mm (0.91 in) dia. |
|
ST30031000 ( — ) Puller |
 |
Removing wheel bearing inner race (outer) |
|
ST35321000 ( — ) Drift |
 |
a: 49 mm (1.93 in) dia. b: 41 mm (1.61 in) dia. |
|
ST35271000 ( — ) Drift |
 |
Installing wheel bearing a: 72 mm (2.83 in) dia. b: 63 mm (2.48 in) dia. |
|
ST33061000 ( — ) Drift |
|
Installing wheel hub a: 38 mm (1.50 in) dia. b: 28.5 mm (1.122 in) dia. |
|
KV38107900 (NI-52469-1)) Differential side oil seal protector |
 |
Installing drive shaft A: 32 mm (1.26 in) dia. B: Minimum 23 mm (0.91 in) |
|
(NI-52982) Lock nut chisel (Cape chisel) |
 |
Removing wheel hub lock nut |
|
KV40104000 ( — ) Hub lock nut wrench |
 |
Removing and Installing wheel hub lock nut. a: 85 mm (3.35 in) b: 65 mm (2.56 in) |
Commercial Service Tools
Commercial Service Tools
|
Tool name |
Description |
|
|---|---|---|
|
Ball joint remover |
 |
Removing wheel stud |
|
Power tool |
 |
Loosening nuts, screws and bolts |
|
Drive shaft joint puller |
 |
Removing drive shaft |
|
Lock nut crimp punch (Cold chisel) |
 |
Installing wheel hub lock nut a: 5 mm (0.20 in) b: 7 mm (0.28 in) |
Other materials:
Fuel Pump
Component Inspection
Component Inspection
CHECK FUEL PUMP
Turn ignition switch OFF.
Disconnect “fuel level sensor
unit and fuel pump” harness connector.
Check the resistance between
...
Back-Up Lamp Relay Circuit
Component Function Check
Component Function
Check
CHECK BACK-UP LAMP OPERATION
Ignition switch ON.
With operating the shift selector, check that the
back-up lamp is turn ...
B0002-09 Driver Air Bag Module
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detecting condition
...