Nissan Sentra B18 (2020-2025) Owner's Manual: Flat towing your vehicle
Flat towing
Towing a vehicle with all four wheels on the ground is commonly referred to as flat towing, dinghy towing, or “four-down” towing. This method is sometimes used when towing a vehicle behind a recreational vehicle such as a motorhome.
CAUTION
- Failure to strictly follow these flat towing guidelines may result in severe and costly transmission damage.
- When flat towing your Nissan Sentra, always tow the vehicle forward and never backward.
- Never tow a front-wheel-drive Nissan Sentra with the front wheels on the ground, as this can cause serious damage to the drivetrain and powertrain components.
- DO NOT flat tow any Nissan Sentra equipped with a Continuously Variable
Transmission (CVT).
Doing so WILL cause internal transmission damage due to insufficient transmission lubrication.
Manual Transmission
- Always tow vehicles with a manual transmission in the N (Neutral) position.
- After every 500 miles (805 km) of towing, start the engine and allow it to idle for at least two minutes with the transmission in N (Neutral). Failure to perform this procedure may result in internal transmission damage.
Continuously Variable Transmission
To tow a Nissan Sentra equipped with a Continuously Variable Transmission, an approved vehicle dolly MUST be placed under the drive wheels. Always adhere to the dolly manufacturer’s instructions and safety recommendations when using their equipment.
Other materials:
Maintenance requirements
Regular day-to-day and scheduled maintenance is essential to keep your Nissan
Sentra in good mechanical condition while preserving emissions control and engine
performance.
It is the responsibility of the vehicle owner to ensure that all scheduled maintenance
and general maintenance tasks are ...
C1608-45 Control Unit
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
Cvt Position
Inspection
Inspection
Place selector lever in “P” position,
and place ignition switch ON (engine stop).
Make sure that selector lever can
be shifted to other than “P” position when brake pedal is depressed.
Also make sure that selector lever can be shifted from “P” ...