Nissan Sentra B18 (2020-2025) Service Manual: Engine Does Not Start When Intelligent Key Is Inside of Vehicle (one Key)
Diagnosis Procedure
Diagnosis Procedure
DESCRIPTION
Engine does not start when push-button ignition switch is pressed. (One Intelligent Key has the symptom, other keys operate normally.)
SYMPTOM TABLE (ONE INTELLIGENT KEY HAS THE SYMPTOM, OTHER KEYS OPERATE NORMALLY)
|
Door lock operation (remote keyless entry) |
Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) |
Engine started with push-button ignition switch operation (Intelligent Key is within the detection area of inside key antenna) |
Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) |
|---|---|---|---|
|
OK |
OK |
No crank, No start |
No crank, No start |
DIAGNOSIS PROCEDURE
-
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
-
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
GO TO 2.
-
-
REGISTER INTELLIGENT KEY
-
CONSULT-
Register the Intelligent Key. Refer to CONSULT immobilizer mode and follow the on-screen instructions.
-
Check operation after replacement.
-
Is the inspection result normal?
YES >>Inspection End.
NO >>GO TO 3.
-
-
REPLACE INTELLIGENT KEY
-
CONSULT-
Replace the Intelligent Key and perform registration again. Refer to CONSULT immobilizer mode and follow the on-screen instructions.
-
Check operation after replacement.
-
Is the inspection result normal?
YES >>Inspection End.
NO >>GO TO 4.
-
-
REPLACE INTELLIGENT KEY UNIT
-
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check operation after replacement.
-
Is the inspection result normal?
YES >>Inspection End.
NO >>Check intermittent incident. Refer to Intermittent Incident.
-
Other materials:
B2c20-12 Starter Cut Relay
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen items
(Trouble diagnosis
content)
DTC detecting condition
...
Manifold Absolute Pressure Sensor
Component Inspection
Component Inspection
CHECK MANIFOLD ABSOLUTE PRESSURE
(MAP) SENSOR-1
Turn ignition switch OFF.
Start engine and warm it up to normal
operating temperature.
Turn ...
Component Parts
Meter System
Component Parts Location
Component Parts
Location
MODELS WITH CVT
A.
View of engine assembly removed
...