Nissan Sentra B18 (2020-2025) Service Manual: Emblem
Exploded View
Exploded View
|
1. |
Emblem A |
2. |
Emblem B (If equipped) |
3. |
Emblem C |
||
Removal and Installation
Removal and Installation
REMOVAL
Remove the emblem from the panel heating with a heat gun.
CAUTION:
Do not damage the painted surface of the panel when removing the emblem.
INSTALLATION
Note:
-
Do not reuse the emblem.
-
Ensure Nissan Sentra vehicle surface temperature is between 25ºC (77ºF) to 50ºC (122ºF).
-
The following figure shows the fixing position of the emblem.
-
The central position of the left and right of emblem D should be measured between the left and right end portions of the trunk lid assembly. Then attach the emblem at the center of the trunk lid assembly.
Remove grease, dust, etc. from the emblem and Nissan Sentra vehicle surface.
Install the emblem to the vehicle surface.
Using a roller, or suitable tool, apply even pressure to firmly affix the emblem to Nissan Sentra vehicle surface.
|
1. |
Emblem C |
2. |
Trunk lid assembly |
3. |
Emblem A |
|
4. |
Emblem B (if equipped) |
||||
|
A |
: 0.0 (0.0) |
B |
: 48.6 (1.9) |
C |
: 250.3 (9.9) |
D |
: 213.3 (8.4) |
|
E |
: 60.4 (2.4) |
F |
: 63.5 (2.5) |
G |
: 68.7 (2.7) |
H |
: 396.6 (15.6) |
|
J |
: 61.9 (2.4) |
K |
: 60.5 (2.4) |
||||
Other materials:
C1711-7b Low Tire Pressure Fl
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure rep ...
Ignition Coil
Exploded View
Exploded View
1.
Ignition coil
2.
Spark plug
3.
Rocker ...
U1040 Eng Comm Circuit
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...