Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. CHECK COMBINATION SWITCH CIRCUIT SHORT TO BATTERY

      1. Ignition switch OFF.

      2. Disconnect combination switch connector and BCM connector M83.

      3. Check voltage between combination switch harness connector and ground.

        +

        Voltage

        (Approx.)

        Combination switch

        Connector

        Terminal

        M28

        1

        Ground

        0 V

        3

        4

        6

        8

        13

        7

        15

        10

        5

        2

        12

    Is the inspection result normal?

    YES>>

    GO TO 2.

    NO>>

    Repair or replace harness or connectors.

  2. PERFORM “DATA MONITOR” OF BCM (COMB SW)

    1. CONSULT

      Select “Data Monitor” mode of "BCM(COMB SW)" to check for any malfunctioning item. Refer to Symptom Table.

    Is the inspection result normal?

    YES >>

    Replace combination switch. Refer to Removal and Installation.

    NO >>

    Replace BCM. Refer to Removal and Installation.

Dtc Confirmation Procedure
DTC Confirmation Procedure DTC CONFIRMATION CONSULT Erase DTC. Ignition switch ...

B2c95-64 Combination Switch
...

Other materials:

P155b Energy Management Control
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

Removal and Installation
Removal and Installation REMOVAL Remove wheel cover (if equipped). Remove wheel nuts using power tool. Refer to Exploded View. Remove wheel and tire. INSTALLATION Installation is in the reverse order of removal. CAUTION: When installing w ...

Engine compartment check locations
MRA8DE engine Engine oil filler cap Brake and clutch (if so equipped) fluid reservoir Air cleaner Battery Fuse/fusible link box Engine coolant reservoir Radiator cap Engine oil dipstick Drive belt location Windshield-washer fluid reservoir ...

© 2014-2026 Copyright www.nisentra.com