Nissan Sentra B18 (2020-2025) Service Manual: P155b Energy Management Control

Nissan Sentra B18 (2020-2025) Service Manual / Engine / Work Procedure (After Replacing Electric Throttle Control Actuator) / Dtc/circuit Diagnosis / P155b Energy Management Control

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P155B	Energy management control (Energy management control)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	ECM power supply
		Threshold	Battery voltage measured by ECM below or above threshold.
		Diagnosis delay time	20 seconds or more

POSSIBLE CAUSE

Harness or connectors
ECM
IPDM E/R
Battery
Generator

FAIL-SAFE

Engine Control System

Not applicable

Idle Start/Stop System

When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.

When ECM detects error while operating the idle start/stop system, ECM restarts the engine.

Confirmation Procedure

Confirmation Procedure

CHECK DTC PRIORITY

If DTC P155B is displayed with DTC P155E and P155F first perform the trouble diagnosis for DTC P155E andP155F.

Witch DTC is detected?
YES >>
Refer to DTC Index.
NO >>
GO TO 2.
PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>
GO TO 3.
DTC CONFIRMATION PROCEDURE
1. 1. Start engine and let it idle for at least 20 seconds.
2. Check DTC.
Witch DTC is detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO-1 >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>
Confirmation after repair: INSPECTION END

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK CHARGE SYSTEM

Check charge system. Refer to Work Flow (With 165-DSS-5000P) or Work Flow (Without 165-DSS-5000P).

Witch DTC is detected?
YES >>
INSPECTION END
NO >>
Repair or replace the error-detected parts.

P1536 Ascd System

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble ...

P155d Generator

Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms ( ...

Other materials:

The braking distance is long
Diagnosis Procedure CAUTION: The stopping distance on slippery road surfaces might be longer with the ABS operating than when the ABS is not operating. 1.CHECK ABS FUNCTION Turn ignition switch OFF. Disconnect ABS actuator and electric unit (control unit) connector to deactivate ...

Removal & Installation
Removal & Installation REMOVAL Remove trunk lid finisher. Refer to Removal and Installation. Remove trunk lid dampener bolts and trunk lid dampener. . Disconnect the harness connector from the trunk lid opener request switch. Release pawl and remove the trunk ...

Rear-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint in the Nissan Sentra. Failure to activate and use the ALR mode will prevent the child restraint from being properly secured. An improperly installed restraint may tip or loos ...