Nissan Sentra B18 (2020-2025) Service Manual: P155d Generator
Dtc Description
DTC Description
DTC DETECTION LOGIC
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|
P155D |
GENERATOR |
A |
Diagnosis condition |
Engine running at idle |
|
Signal (terminal) |
Generator mechanical malfunction signal |
|||
|
Threshold |
ECM receives mechanical malfunction signal sent from generator |
|||
|
Diagnosis delay time |
— |
|||
|
B |
Diagnosis condition |
Engine running at idle |
||
|
Signal (terminal) |
Generator electrical malfunction signal |
|||
|
Threshold |
ECM receives electrical malfunction signal sent from generator |
|||
|
Diagnosis delay time |
— |
|||
POSSIBLE CAUSE
Generator
FAIL-SAFE
Engine Control System
Not applicable
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited.
When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
Confirmation Procedure
Confirmation Procedure
-
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted. always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
-
-
PERFORM DTC CONFIRMATION PROCEDURE
-
Start the engine and let it idle at least 10 seconds.
-
Check DTC.
Is DTC detected?
YES >>Proceed to DTC Diagnosis Procedure.
NO-1 >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2 >>Confirmation after repair: INSPECTION END
-
Dtc Diagnosis Procedure
DTC Diagnosis Procedure
-
CHECK CHARGING SYSTEM
Perform trouble diagnosis for charging system. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES >>Replace generator. Refer to Removal and Installation.
NO >>Repair or replace error-detected parts.
Other materials:
Component Parts. Door & Lock System
Door & Lock System
Component Parts Location
Component Parts
Location
A
View with CVT shift selector
B
Left side of instrument ...
Work Procedure (Before Replacing Electric
Throttle Control Actuator)
CHECK DTC
Perform DTC P0101 confirmation procedure.
Refer to Confirmation Procedure.
Is the DTC P0101 displayed?
YES >>
GO TO 2.
NO >>
Replace electric throttle control actuator.
Refer to Removal and ...
Defogger. Precaution. Precautions
Precautions
Precaution for Supplemental Restraint System (srs) "air Bag" and "seat Belt Pre-Tensioner"
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as
“AIR BAG� and “SEAT BELT PRE-T ...