Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. CHECK TRUNK LID OPENER INPUT SIGNAL

      1. Ignition switch OFF.

      2. Disconnect trunk lid opener switch connector.

      3. Check voltage between trunk lid opener switch harness connector and ground.

        (+)

        (–)

        Voltage

        (Approx.)

        Trunk lid opener switch

        Connector

        Terminal

        M15

        2

        Ground

        Battery voltage

    Is the inspection result normal?

    YES >>

    GO TO 3.

    NO >>

    GO TO 2.

  2. CHECK TRUNK LID OPENER SWITCH CIRCUIT

      1. Disconnect BCM connector.

      2. Check continuity between BCM harness connector and trunk lid opener switch harness connector.

        BCM

        Trunk lid opener switch

        Continuity

        Connector

        Terminal

        Connector

        Terminal

        M84

        12

        M15

        2

        Yes

      3. Check continuity between BCM harness connector and ground.

        BCM

        —

        Continuity

        Connector

        Terminal

        M84

        12

        Ground

        No

    Is the inspection result normal?

    YES >>

    Replace BCM. Refer to Removal and Installation.

    NO >>

    Repair or replace harness.

  3. CHECK TRUNK LID OPENER SWITCH GROUND CIRCUIT

    1. Check continuity between trunk lid opener switch harness connector and ground.

      Trunk lid opener switch

      —

      Continuity

      Connector

      Terminal

      M15

      3

      Ground

      Yes

    Is the inspection result normal?

    YES >>

    GO TO 4.

    NO >>

    Repair or replace harness.

  4. CHECK TRUNK LID OPENER SWITCH

    1. Refer to Component Inspection.

    Is the inspection result normal?

    YES>>

    Replace BCM. Refer to Removal and Installation.

    NO>>

    Replace trunk lid opener switch. Refer to Removal and Installation.

Confirmation Procedure
Confirmation Procedure PERFORM DTC CONFIRMATION PROCEDURE CONSULT Ignition switch ON. ...

B2001-45 Intelligent Key Unit
...

Other materials:

Wheel Bearing
Wheel Bearing Item Standard Axial end play 0.05 mm (0.002 in) or less ...

P0138 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/ F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. MALFUNCTION A To judge the malfunction ...

Storage pouch
A storage pouch is located on the front of the driver’s and passenger’s seats. WARNING Do not store angular, sharp, heavy objects or objects that cannot fully fit inside the pouch because they might increase the likelihood of an injury in a crash. To ensure ...

© 2014-2026 Copyright www.nisentra.com