Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C161c-83 Steering Angle Sensor System / Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK VEHICLE SPECIFICATION
1. Check vehicle specification.
>>
GO TO 2.
PERFORM SELF DIAGNOSTIC RESULT
1. 1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of "CHASSIS CONTROL".
Is any DTC detected?
YES >>
Check the DTC. Refer to DTC Index.
NO >>
GO TO 3.
CHECK CONNECTOR AND TERMINAL
1. 1. Ignition switch OFF.
  2. Disconnect chassis control module harness connector.
  3. Disconnect EPS control unit harness connector.
  4. Check the connector for disconnection or looseness.
  5. Check the pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES >>
GO TO 4.
NO >>
Repair or replace harness, connector, or terminal, securely lock the connector.
PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Connect chassis control module harness connector.
  2. Connect EPS control unit harness connector.
  3. Ignition switch ON.
  4. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
  5. Ignition switch OFF and wait for at least 10 seconds.
  6. Ignition switch ON.
  7. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “C161C-83” detected?
YES >>
EPS control unit is malfunctioning. Replace steering gear column assembly. Refer to Removal and Installation.
NO >>
Inspection End.

Confirmation Procedure

Confirmation Procedure PRECONDITIONING If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait ...

C161c-86 Steering Angle Sensor System

...

Other materials:

Work Flow
Work Flow OVERALL SEQUENCE DETAILED FLOW GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction ...

B1428 Seat belt buckle switch LH
Description DTC B1428 SEAT BELT BUCKLE SWITCH LH The air bag diagnosis sensor unit monitors the seat belt buckle switch LH status. If the control unit detects an open or short condition in the circuit, it will set the DTC. PART LOCATION Refer to SRC-5, "Component Parts Location". ...

Basic inspection
Diagnosis and repair workflow Work Flow (With GR8-1200 NI) STARTING SYSTEM DIAGNOSIS WITH GR8-1200 NI To test the starting system, use the following special service tool: GR8-1200 NI Multitasking battery and electrical diagnostic station NOTE: Refer to the diagnostic station Instruction M ...