Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C161c-83 Steering Angle Sensor System / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “C161C-83” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure CHECK VEHICLE SPECIFICATION Check vehicle specification. >> GO TO 2. PERFORM SE ...

Other materials:

RAB system limitations
WARNING The following list outlines the operational limitations of the Rear Automatic Braking (RAB) system. Failure to comply with these warnings and usage instructions may result in serious injury or death. When the Nissan Sentra approaches an obstacle while the accelerator or brake ped ...

Dtc Description
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

Tcm
Exploded View Exploded View 1. TCM upper bracket 2. TCM 3. TCM brack ...