Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C161c-82 Steering Angle Sensor System / Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK VEHICLE SPECIFICATION
1. Check vehicle specification.
>>
GO TO 2.
PERFORM SELF DIAGNOSTIC RESULT
1. 1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of "CHASSIS CONTROL".
Is any DTC detected?
YES >>
Check the DTC. Refer to DTC Index.
NO >>
GO TO 3.
CHECK CONNECTOR AND TERMINAL
1. 1. Ignition switch OFF.
  2. Disconnect chassis control module harness connector.
  3. Disconnect EPS control unit harness connector.
  4. Check the connector for disconnection or looseness.
  5. Check the pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES >>
GO TO 4.
NO >>
Repair or replace harness, connector, or terminal, securely lock the connector.
PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Connect chassis control module harness connector.
  2. Connect EPS control unit harness connector.
  3. Ignition switch ON.
  4. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
  5. Ignition switch OFF and wait for at least 10 seconds.
  6. Ignition switch ON.
  7. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “C161C-82” detected?
YES>>
EPS control unit is malfunctioning. Replace steering gear column assembly. Refer to Removal and Installation.
NO>>
Inspection End.

Confirmation Procedure

Confirmation Procedure PRECONDITIONING If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait ...

C161c-83 Steering Angle Sensor System

...

Other materials:

Calibrating Camera Image (intelligent Around View Monitor)
Description Description Calibration must be performed after removing/replacing the cameras, removing parts (e.g. front grille, door mirror, and others) mounted on the cameras, or replacing the Around view monitor control unit. The use of CONSU ...

Power Supply and Ground Circuit (8ch Can Gateway)
Diagnosis Procedure Diagnosis Procedure CHECK FUSE Check that the following fuse are not blown. Signal name Fuse ...

P0715 Input speed sensor A
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0715 INPUT SPEED SENSOR A (Input/Turbine Speed Sensor A Circuit) The primary speed sensor value is less than 150 r ...