Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C161c-82 Steering Angle Sensor System / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
Is DTC “C161C-82” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure CHECK VEHICLE SPECIFICATION Check vehicle specification. >> GO TO 2. PERFORM SE ...

Other materials:

Exploded View
Exploded View 1. Steering knuckle 2. Splash guard 3. Wheel bearing ...

Fuel Injector and Fuel Tube
Exploded View Exploded View 1. High pressure fuel rail 2. Fuel injector assembly 3. ...

Dtc Diagnosis Procedure
DTC Diagnosis Procedure CHECK OUTSIDE KEY ANTENNA INPUT SIGNAL 1 Ignition switch ON. Check signal between Intelligent Key unit harness connector and ground using oscill ...