Nissan Sentra B18 (2020-2025) Service Manual: Dtc Diagnosis Procedure
-
PERFORM SELF DIAGNOSIS RESULT
-
CONSULT-
Ignition switch ON.
-
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
-
Ignition switch OFF and wait for at least 10 seconds.
-
Start the engine.
CAUTION:
Never drive the Nissan Sentra vehicle.
-
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
-
Is DTC “C1606-96” detected?
YES >>EPS motor is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>Check pin terminal and connection of each harness connector for malfunctioning conditions.
-
Confirmation Procedure
Confirmation Procedure
PRECONDITIONING
If “Confirmation Procedure” has been
previously conducted, always place the ignition switch OFF and wait
...
Other materials:
Inspection
Inspection
DESCRIPTION
Measure the wheel alignment under unladen
conditions.
Note:
“Unladen conditions” means that fuel,
engine coolant, and lubricants are full. Spare tire, jack, hand
tools and mats are in designated positions.
PRELIMINARY
Check the following:
Tires ...
Door Hinge
Removal and Installation
Removal and Installation
REMOVAL
Remove
front door assembly. Refer to Removal and Installation.
Remove
front fender. Refer to Removal and Installation.
Remove
front door hinge bolts (body side) and front door
hinge.
INSTALLATION
Instal ...
Diagnosis Procedure
Diagnosis Procedure
CHECK COMBINATION SWITCH (LIGHTING
AND TURN SIGNAL SWITCH) OPERATION
Check that the headlamps operate normally by
operating the combination switch (lighting and turn signal
switch).
Do t ...
