Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1608-43 Control Unit

Nissan Sentra B18 (2020-2025) Service Manual: C1608-43 Control Unit

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
C1608–43	CONTROL UNIT (Control unit)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	-
		Threshold	When the internal malfunction (RAM malfunction) is detected in EPS control unit.
		Diagnosis delay time	1 second or more

POSSIBLE CAUSE

EPS control unit

FAIL-SAFE

Manual steering state

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-43” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS RESULT
1. CONSULT
  1. Ignition switch ON.
  2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
  3. Ignition switch OFF and wait for at least 10 seconds.
  4. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  5. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-43” detected?
YES>>
EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO>>
Check pin terminal and connection of each harness connector for malfunctioning conditions.

 C1606-96 Eps Motor

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1606–96 EPS MOTOR (EPS motor) 1 Diagnosis...

 C1608-44 Control Unit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1608–44 CONTROL UNIT (Control unit) Diagn...

Other materials:

Forward-facing child restraint installation using the seat belts
WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must always be used when installing a child restraint in the Nissan Sentra. Failure to activate and use the ALR mode will prevent the child restraint from being properly secured. An unsecured or unstable restraint may tip ...

P0117 Ect Sensor
Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

Preparation. Preparation
Preparation Special Service Tools Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name ...