Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1608-44 Control Unit

Nissan Sentra B18 (2020-2025) Service Manual: C1608-44 Control Unit

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
C1608–44	CONTROL UNIT (Control unit)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	-
		Threshold	When the internal malfunction (RAM malfunction) is detected in EPS control unit.
		Diagnosis delay time	1 second or more

POSSIBLE CAUSE

EPS control unit

FAIL-SAFE

Manual steering state

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-44” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSIS RESULT
1. CONSULT
  1. Ignition switch ON.
  2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
  3. Ignition switch OFF and wait for at least 10 seconds.
  4. Start the engine.
    
    CAUTION:
    
    Never drive the Nissan Sentra vehicle.
  5. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1608-44” detected?
YES >>
EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>
Check pin terminal and connection of each harness connector for malfunctioning conditions.

 C1608-43 Control Unit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1608–43 CONTROL UNIT (Control unit) Diagn...

 C1608-45 Control Unit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1608–45 CONTROL UNIT (Control unit) Diagn...

Other materials:

B2046-55 Eeprom
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...

Icc Steering Switch (other Than Main Switch) Does Not Function
Diagnosis Procedure Diagnosis Procedure ICC MAIN switch can be turned ON/OFF, but the operation of RES+ switch, CANCEL switch, and DISTANCE switch cannot be performed during ICC system operation. Note: Resume is not accepted when the following condition is met. Wh ...

Doors
When the doors of the Nissan Sentra are locked using any of the available locking methods, they cannot be opened from either the inside or outside door handles. To open the doors, they must first be properly unlocked using the key, Intelligent Key, or door lock controls. WARNING Always ke ...