The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
C1733-68 |
Tire pressure sensor RL (Tire pressure sensor rear left) |
1 |
Diagnosis condition |
Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more. Note:
When DTC is memorized, DTC is displayed again at ignition switch ON. |
|
Signal (terminal) |
Temperature data signal. |
|||
|
Threshold |
Malfunction in the tire pressure data from the rear left tire pressure sensor. |
|||
|
Diagnosis delay time |
1 second or less. |
|||
|
2 |
Diagnosis condition |
Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more. Note:
When DTC is memorized, DTC is displayed again at ignition switch ON. |
||
|
Signal (terminal) |
Temperature data signal. |
|||
|
Threshold |
Malfunction in the tire temperature data from the rear left tire pressure sensor. |
|||
|
Diagnosis delay time |
1 second or less. |
|||
|
3 |
Diagnosis condition |
Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more. Note:
When DTC is memorized, DTC is displayed again at ignition switch ON. |
||
|
Signal (terminal) |
Temperature data signal. |
|||
|
Threshold |
Malfunction in the G sensor data from rear left tire pressure sensor. |
|||
|
Diagnosis delay time |
1 second or less. |
|||
POSSIBLE CAUSE
Rear left tire pressure sensor
FAIL-SAFE
—
Dtc Confirmation ProcedureOn board refueling vapor recovery(ORVR)
Component Function Check
1.CHECK ORVR FUNCTION
Check whether the following symptoms are present.
Fuel odor from EVAP canister is strong
Cannot refuel/Fuel odor from the fuel filler opening is strong while
refueling.
Are any symptoms present?
YES >> Proceed to EC-468, "Diagn ...
Power supply and ground circuit
Av control unit
Av control unit : diagnosis procedure
Regarding Wiring Diagram information, refer to AV-234, "Wiring Diagram".
1.Check fuse
Check that the following fuses are not blown.
Are the fuses blown?
Yes >> replace the blown fuse after repairing the affected circuit.
...
B20c7-15 A/c Clutch
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...