Nissan Sentra B18 (2020-2025) Service Manual: Dtc Confirmation Procedure
-
PERFORM DTC CONFIRMATION
-
CONSULT-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.
-
Select “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.
-
Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.
-
Is DTC “C1711-7A" detected?
YES >>Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional informatio ...
Other materials:
Disassembly and Assembly
Disassembly and Assembly
Warning:
Clean dust on the brake caliper using a vacuum
dust collector to minimize the hazards of airborne particles or
other material.
CAUTION:
Do not reuse drained brake fluid.
Do not damage the pist ...
P1650 Starter motor relay 2
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. ECM transmits
a control signal to IPDM E/R via BCM by CAN communication.
Under normal conditions, ECM controls and maintains the starter relay in OFF
state during following condition:
...
Combination Switch
Exploded View
Exploded View
1.
Steering column assembly
2.
Combination switch
A.
...
