Nissan Sentra B18 (2020-2025) Service Manual: Door Lock
Removal and Installation
REMOVAL
Remove outside handle. Refer to Removal and Installation.
Remove bolts and front door rear run. Refer to Exploded View.
Remove door lock bolts and remove front door lock.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Do not reuse front door lock bolts.
-
After installation, check door lock cables are properly engaged to inside handle and outside handle bracket.
-
When installing door key cylinder rod (LH only), be sure to rotate door key cylinder rod holder until a click is felt.
-
After installation, check door open/close and lock/unlock operation.
Exploded View
Exploded View
1
.
Outside handle
2.
...
Inside Handle
Removal and Installation
Removal and Installation
REMOVAL
Remove
front door finisher. Refer to Removal and Installation.
Remove
screws and door inside handle.
INSTALLATION
I ...
Other materials:
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Protection Function
Protection Function
EPS control unit decreases the output signal to
EPS motor while extremely using the power steering function (e.g.,
full steering) consecutively for protecting EPS motor and EPS
control unit (overload protection control). While activating
overload protection cont ...
Inspection
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment
(for HFO-1234yf) or manifold gauge.
Start the engine, and set to the following
condition.
Test condition
...
