CHECK FUSE
Ignition switch OFF.
Check that any of the following fuses are not blown (open):
|
Signal name |
Fuse No. |
Capacity |
|---|---|---|
|
Ignition power supply |
6 |
10 A |
|
44 |
10 A |
Is the inspection result normal?
YES >>GO TO 2.
NO >>Replace the blown fuse after repairing the affected circuit.
CHECK HEATED STEERING WHEEL RELAY POWER SUPPLY
Disconnect heated steering wheel relay connector.
Ignition switch ON.
Check voltage between heated steering wheel relay harness connector and ground.
|
(+) |
(-) |
Voltage (Approx.) |
|
|---|---|---|---|
|
Heated steering wheel relay |
|||
|
Connector |
Terminal |
||
|
M75 |
1 |
Ground |
Battery voltage |
|
3 |
|||
Is the inspection result normal?
YES >>GO TO 3.
NO >>Repair or replace harness.
CHECK HEATED STEERING WHEEL RELAY CONTROL SIGNAL CIRCUIT
Ignition switch OFF.
Disconnect A/C auto amp. connector.
Check continuity between heated steering wheel relay harness connector and A/C auto amp. harness connector.
|
Heated steering wheel relay |
A/C auto amp. |
Continuity |
||
|---|---|---|---|---|
|
Connector |
Terminal |
Connector |
Terminal |
|
|
M75 |
2 |
M34 |
56 |
Yes |
Check continuity between A/C auto amp. harness connector and ground.
|
A/C auto amp. |
– |
Continuity |
|
|---|---|---|---|
|
Connector |
Terminal |
||
|
M34 |
56 |
Ground |
No |
Is the inspection result normal?
YES >>GO TO 4.
NO >>Repair or replace harness.
CHECK HEATED STEERING WHEEL RELAY
Check heated steering wheel relay.
Refer to Component Inspection.
Is the inspection result normal?
YES >>Inspection End.
NO >>Replace heated steering wheel relay.
Component Function Check
Component InspectionSeats
This section describes the seat design and adjustment features of the Nissan
Sentra, helping drivers and passengers achieve a safe, comfortable, and ergonomically
correct seating position.
WARNING
Do not ride in a moving Nissan Sentra when the seatback is reclined.
This is extremely ...
Wheel Bearing
Wheel Bearing
Item
Standard
Axial end play
0.05 mm (0.002 in) or
less
...
Diagnosis Procedure
Diagnosis Procedure
CHECK DTC WITH COMBINATION METER
Check that DTC is not detected with combination
meter.
Refer to DTC Index (with Type A meter) or DTC Index (with Type B meter).
Is the inspection result normal?
...