Nissan Sentra Service Manual: Diagnosis and repair work flow

Nissan Sentra Service Manual / Suspension / Road wheels & Tires / Basic inspection / Diagnosis and repair work flow

Work Flow

NOTE:

The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS transmitter IDs
Display tire pressure reported by the TPMS transmitter
Read TPMS DTCs
Register TPMS transmitter IDs

1.COLLECT INFORMATION FROM CUSTOMER

Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).

>> GO TO 2.

2.TIRE PRESSURE INSPECTION

Check the tire pressure for all wheels. Refer to WT-54, "Tire Air Pressure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace tire(s) or wheel(s).

3.CHECK LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp illuminates for approximately 1 second after the ignition switch is turned ON, then turns OFF.

Does the low tire pressure warning lamp turn OFF? YES >> Inspection End.

NO >> GO TO 4.

4.PERFORM SELF DIAGNOSTIC RESULT

Perform self diagnostic result. Refer to WT-11, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" (with Intelligent Key system) or WT-13, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" (without Intelligent Key system).

Are any DTCs displayed? YES >> Refer to BCS-49, "DTC Index" (with Intelligent Key system) or BCS-109, "DTC Index" (without Intelligent Key system). If two or more DTCs are displayed, refer to BCS-48, "DTC Inspection Priority Chart" (with Intelligent Key system) or BCS-108, "DTC Inspection Priority Chart" (without Intelligent Key system).

NO >> GO TO 5.

5.PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM

Perform diagnosis applicable to the symptom. Refer to WT-36, "Symptom Table".

>> GO TO 6.

6.FINAL CHECK

Perform self diagnostic result again, and check that the malfunction is repaired. After checking, erase the self diagnosis memory. Refer to WT-11, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" (with Intelligent Key system) or WT-13, "AIR PRESSURE MONITOR : CONSULT Function (BCM - AIR PRESSURE MONITOR)" (without Intelligent Key system).

Basic inspection

...

ID registration procedure

Description This procedure must be performed after replacing wheels, transmitters or the BCM, or rotating wheels. Work Procedure TPMS ID registration can be performed using one of the following ...

Other materials:

Electric ignition system
ELECTRIC IGNITION SYSTEM : System Description SYSTEM DIAGRAM *1: CVT models *2: M/T models Input/output signal chart Sensor Input Signal to ECM ECM function Actuator Crankshaft position sensor (POS) Engine speed*3 Piston position Ignition ...

Precautions for refrigerant system service
WORKING WITH HFC-134a (R-134a) CAUTION: CFC-12 (R-12) refrigerant and HFC-134a (R-134a) refrigerant are not compatible. Compressor malfunction is likely to occur if the refrigerants are mixed, refer to вЂњCONTAMINATED REFRIGERANTвЂќ below. To determine the purity of HFC-134a (R- ...

Symptom diagnosis
Squeak and rattle trouble diagnoses Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any custome ...