Nissan Sentra B18 (2020-2025) Service Manual: Cowl Top
Exploded View
Exploded View
|
1. |
Cowl top side trim cover (RH) |
2. |
Cowl top |
3. |
Cowl top grille cap |
|
4. |
EPT sealer assembly |
5. |
Cowl top seal |
6. |
Cowl top side trim cover (LH) |
|
|
Front |
Removal and Installation
Removal and Installation
COWL TOP
REMOVAL
Remove front wiper arm (LH/RH). Refer to Removal and Installation.
Remove cowl top side trim cover (LH/RH). Refer to Exploded View.
Remove cowl top clips. Refer to Exploded View.
Pull up on
cowl top to release from windshield glass.
CAUTION:
When performing the procedure after removing cowl top, cover the lower end of windshield glass with urethane etc.
Remove cowl top.
Remove the following parts from the cowl top (if necessary):
-
Cowl top seal
-
EPT sealer assembly
-
Cowl top grille cap
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
-
Clean the joint between the cowl top and the windshield.
-
Replace the EPT sealer assembly when reusing cowl top.
-
Do not wash or expose Nissan Sentra vehicle to a wet environment within 24 hours of installation.
Other materials:
Trunk Opener Request Switch
Component Function Check
Component Function Check
CHECK FUNCTION
CONSULT
Select "Request switch BD/TR" in "Data Monitor"
mode of "BCM(TRUNK)".
Select that the functi ...
Led Headlamp Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK LED HEADLAMP GROUND CIRCUIT
Ignition switch OFF.
Disconnect front combination lamp connector.
Check con ...
Turn Signal Lamp Circuit
Component Function Check
Component Function
Check
CHECK TURN SIGNAL LAMP OPERATION
CONSULT
Select “FLASHER� in "Active Test" mode of “BCM(FLASHER)".
With operating the t ...
