Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure
-
PRECONDITIONING
-
If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
-
-
DTC REPRODUCTION PROCEDURE
-
CONSULT-
Ignition switch ON.
-
Select “Self Diagnostic Result” mode of “EPS/DAST 3”.
-
Is DTC “U2140-87” detected?
YES >>Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis cont ...
Other materials:
Door Motor Starting Position Reset
Description
Description
Reset signal is transmitted from A/C auto amp. to
air mix door motor and mode door motor. Starting position reset can
be performed.
Note:
During reset, DEF switch indicator blinks.
When air mix door motor or mode d ...
P10c3 Internal Control Module Fuel Injector
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...
Before starting the engine
Make sure the area around the vehicle is
clear.
Check fluid levels such as engine oil, coolant,
brake and clutch fluid(if so equipped),
and windshield-washer fluid as frequently as
possible, or at least whenever you refuel.
Check that all windows and lights are clean.
Visually inspe ...
