Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Configuration (intelligent Key Unit)

Nissan Sentra B18 (2020-2025) Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Basic Inspection / Intelligent Key Unit / Configuration (intelligent Key Unit)

Work Procedure

Work Procedure

Vehicle specification needs to be written with CONSULT because it is not written after replacing Intelligent Key unit.

Configuration has follows.

Function

Description

Nissan Sentra Vehicle Configuration

Before ECU Replacement

  • Reads the Nissan Sentra vehicle configuration of current Intelligent Key unit.

  • Saves the read vehicle configuration.

After ECU Replacement

FAST linked

 Note:

This item is displayed, but cannot be monitored.

Manual selection

Writes the Nissan Sentra vehicle configuration with manual selection.

Operation Log Selection

Writes the read Nissan Sentra vehicle configuration.

CAUTION:

When replacing Intelligent Key unit, always perform “Re/programming, Configuration” with CONSULT. Or not doing so, Intelligent Key unit control function does not operate normally.

  • Complete the procedure of “Re/programming, Configuration” in order.

  • Configuration is different for each Nissan Sentra vehicle model. Confirm configuration of each vehicle model.

  • Never save vehicle configuration to Intelligent Key unit except for new Intelligent Key unit.

  • If you set incorrect Nissan Sentra vehicle configuration, incidents might occur.

  1. WRITING MODE SELECTION

    1. CONSULT

      Select “Re/programming, Configuration” .

    When writing saved data>>

    GO TO 2.

    When writing manually>>

    GO TO 3.

  2. WHEN WRITING SAVED DATA

    1. CONSULT

      Select the operation according to the CONSULT screen.

    >>

    GO TO 4.

  3. WHEN WRITING MANUALLY

    1. CONSULT

      1. Ignition switch ON.

      2. Select “Manual selection”.

      3. Select the “Type ID” searched by using “Global Web-FAST” (NISSAN parts catalogue) to write the “Type ID” into the Intelligent Key unit.

        CAUTION:

        • Thoroughly read and understand the Nissan Sentra vehicle specification. ECU control may not operate normally if the setting is not correct.

        • Make sure to select “SETTING” even if the indicated configuration of brand new Intelligent Key unit is same as the desirable configuration. If not, configuration which is set automatically by selecting Nissan Sentra vehicle model cannot be memorized.

    >>

    GO TO 4.

  4. OPERATION CHECK

    1. Confirm that each function controlled by Intelligent Key unit operates normally.

    >>

    Work End.

Additional Service When Replacing Intelligent Key Unit
Work Procedure Work Procedure Perform the following operations when replacing Intelligent Key unit: CAUTION: When replacing the Intelligent Key unit, always replace it with a n ...

Door & Lock :: Dtc/circuit Diagnosis
...

Other materials:

Diagnosis System (bcm)
Common Item Consult Function (bcm - Common Item) CONSULT Function (BCM - COMMON ITEM) BCM Refer to CONSULT Function (BCM - COMMON ITEM). Intelligent Key Consult Function (bcm - In ...

Ecm branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? Yes > ...

Basic inspection
Diagnosis and repair work flow Work flow Overall sequence Detailed flow 1.Get information for symptom Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the “diagnostic work sheet”. ( ...

© 2014-2026 Copyright www.nisentra.com