Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: Cannot Set Automatic Speed Control Device (ascd)

Diagnosis Procedure

Diagnosis Procedure

  1. PERFORM SELF-DIAGNOSIS

    With CONSULT

    Perform ECM self-diagnosis.

    Is DTC detected?

    YES >>

    Perform diagnosis of applicable.

    NO >>

    GO TO 2.

  2. CHECK BRAKE PEDAL POSITION SWITCH

    Check brake pedal position switch. Refer to Diagnosis Procedure.

    Is the inspection result normal?

    YES >>

    INSPECTION END

    NO >>

    Repair or replace error-detected parts.

    Normal Operating Condition
    Symptom Description Symptom Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the status of that the engine speed is above 2,500 rpm under no load (at 0 km/h an...
    Periodic Maintenance
    Idle Speed Idle Speed : Periodic Maintenance IDLE SPEED : Periodic Maintenance With CONSULT Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT. Without CO...

    Other materials:

    Road Wheels & Tires. Ecu Diagnosis Information. Bcm, Intelligent Key Unit. List of Ecu Reference
    Bcm, Intelligent Key Unit. List of Ecu Reference List of Ecu Reference List of ECU Reference ECU Reference BCM Values on the Di ...

    Remote Keyless Entry Function
    System Diagram System Diagram System Description System Description The Intelligent Key has the same functions as the remote control entry system. Therefore, it can be used in the same manner as the remote controller by operating the door lock/unlock button. OPERATION Re ...

    Id Registration Cannot Be Completed
    Symptom Description Symptom Description The ID of the tire pressure sensor installed in each wheel cannot be registered in the TPMS system. Inspect the tire pressure sensor or the TPMS circuit. Diagnosis Procedure Diagnosis Procedure Note: The Signal Tech II Tool [– (NI-50190)] can ...