Nissan Sentra manuals

Nissan Sentra Service Manual: Body component parts


  1. Moonroof panel assembly
  2. Roof panel assembly
  3. Front roof rail
  4. Roof rail
  5. Rear roof rail
  6. Moonroof frame assembly
  7. Hood assembly
  8. Front fender (RH, LH)
  9. Outer front door panel (RH, LH)
  10. Outer rear door panel (RH, LH)
  11. Front door assembly (RH, LH)
  12. Rear door assembly (RH, LH)
  13. Front body side outer (RH, LH)
  14. Rear body side outer (RH, LH)
  15. Rear wheel housing outer (RH, LH)
  16. Rear pillar reinforcement (RH, LH)
  17. Outer sill reinforcement (RH, LH)
  18. Front pillar reinforcement (RH, LH)
  19. Front pillar reinforcement (RH, LH)
  20. Center pillar reinforcement (RH, LH)
  21. Roof side rail reinforcement (RH, LH)
  22. Center pillar inner (RH, LH)
  23. Roof inner side rail (RH, LH)
  24. Rear wheel housing inner (RH, LH)
  25. Rear inner sill extension (RH, LH)
  26. Rear panel assembly (RH, LH)
  27. Rear parcel shelf extension (RH, LH)
  28. Rear panel
  29. Trunk lid assembly

Removal and installation Front


Repairing material
Foam Repair During factory assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam i ...

Removal and installation
...

Other materials:

Service Notice or Precautions for Steering System
In case of removing steering gear assembly, make the final tightening with grounded and unloaded vehicle condition, and then check wheel alignment. Observe the following precautions when disassembling. Before disassembly, thoroughly clean the outside of the unit. ...

Ecm branch line circuit
Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the ECM for damage, bend and loose connection (unit side and connector side). Is the inspection result normal? YES > ...

Symptom diagnosis
Noise, vibration and harshness (NVH) troubleshooting NVH troubleshooting chart Locate the area where noise occurs. Confirm the type of noise. Specify the operating condition of engine. Check specified noise source. If necessary, repair or replace these parts. Closely relate ...

В© 2014-2025 Copyright www.nisentra.com