S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: Additional Service When Replacing Around View Monitor Control Unit

Description

Description

BEFORE REPLACEMENT

When replacing around view monitor control unit, save or print current Nissan Sentra vehicle specification with CONSULT configuration before replacement.

Note:

If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replacing around view monitor control unit.

AFTER REPLACEMENT

CAUTION:

When replacing around view monitor control unit, you must perform “After Replace ECU” with CONSULT.

  • Complete the procedure of “After Replace ECU” in order.

  • If you set incorrect “After Replace ECU”, incidents might occur.

  • Configuration is different for each Nissan Sentra vehicle model. Confirm configuration of each vehicle model.

Work Procedure

Work Procedure

  1. SAVING VEHICLE SPECIFICATION

    1. CONSULT

      Enter “Re/Programming, Configuration” and perform “Before Replace ECU” to save or print current Nissan Sentra vehicle specification.

      Note:

      If “Before Replace ECU” cannot be used, use the “After Replace ECU” or “Manual Configuration” after replacing around view monitor control unit.

    >>

    GO TO 2.

  2. REPLACE AROUND VIEW MONITOR CONTROL UNIT

    1. Replace around view monitor control unit. Refer to Removal and Installation.

    >>

    GO TO 3.

  3. WRITING Nissan Sentra Vehicle SPECIFICATION

    1. CONSULT

      1. Enter "Re/Programming, Configuration".

      2. If “Before Replace ECU” operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press “Confirm” to write Nissan Sentra vehicle specification. Refer to Work Procedure.

      3. If “Before Replace ECU” operation was not performed, select "After Replace ECU" or "Manual Configuration" to write Nissan Sentra vehicle specification. Refer to Work Procedure.

    >>

    GO TO 4.

  4. OPERATION CHECK

    1. Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.

    >>

    Work End.

    Diagnosis and Repair Workflow
    Work Flow Work Flow OVERALL SEQUENCE Reference 1: Refer to CONSULT Function. Reference 2: Refer to DTC Index. Reference 3: Refer to Symptom Table. DETAILED FLOW INTERVIEW AND SY...
    Configuration (around View Monitor Control Unit)
    Description Description Vehicle specification needs to be written with CONSULT because it is not written after replacing around view monitor control unit. Configuration has thre...

    Other materials:

    Operation
    Switch Name and Function Switch Name and Function STEERING SWITCH The steering switch is located on the steering wheel. Transmits the steering switch signal to the combination meter. ...

    P1217 Engine Over Temperature
    Dtc Description DTC Description ECM controls cooling fan to the maximum speed when receives the signal abnormality of each sensor, CAN and IPDM E/R, and severed wire short circuit abnormality. If the cooling fan or another component in the cooling system malfunctions, engine coola ...

    B1383 Incomp Steering Angle Sensor Adjust
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...