DTC Logic
Dtc detection logic
| Dtc | Display item | Malfunction detected condition | Possible causes |
| C1144 | St ang sen signal | When neutral position adjustment of steering angle sensor is not complete. |
|
Dtc confirmation procedure
1.Check self diagnostic result
With consult
Turn ignition switch on.
Perform self diagnostic result.
Is dtc C1144 detected? Yes >> proceed to diagnosis procedure. Refer to brc-82, "diagnosis procedure".
No >> inspection end.
Diagnosis Procedure
1.Adjust the neutral position of steering angle sensor
Perform neutral position adjustment of steering angle sensor. Refer to brc-54, "work procedure".
>> Go to 2.
2.Check self diagnostic result
With consult.
Perform self diagnostic result.
Is dtc c1144 detected? Yes >> go to 3.
No >> inspection end.
3.Check steering angle sensor system
Check steering angle sensor system. Refer to brc-80, "diagnosis procedure".
Is the inspection result normal? Yes >> replace abs actuator and electric unit (control unit). Refer to brc-110, "removal and installation".
No >> repair or replace malfunctioning components.
C1143 Steering angle sensor
C1155 BR Fluid level lowHeadlamp (lo) circuit
Description
The ipdm e/r (intelligent power distribution module engine room) controls the
headlamp low relay based on
inputs from the bcm over the can communication lines. When the headlamp low
relay is energized, power
flows through fuses 43 and 44, located in the ipdm e/r. Power then flows ...
Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat
belt pre-tensioner"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”,
used along
with a front seat belt, helps to reduce the risk or severity of injur ...
Periodic maintenance
Road wheel
Inspection
ALUMINUM WHEEL
Check tires for wear and improper inflation.
Check wheels for deformation, cracks and other damage. If deformed,
remove wheel and check wheel
runout.
Remove tire from aluminum wheel and mount wheel on a balancer machine.
Set dial indicator as ...