Nissan Sentra manuals

Nissan Sentra Service Manual: Without intelligent key system

Removal and installation
Nats antenna amp Removal and installation Removal Remove instrument finisher b. Refer to ip-14, "exploded view". Using a suitable tool release the pawls on either side and remove the ...

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The supplemental restraint system such as “air bag” and “seat belt pre ...

Other materials:

P1650 Starter motor relay 2
Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. ECM transmits a control signal to IPDM E/R via BCM by CAN communication. Under normal conditions, ECM controls and maintains the starter relay in OFF state during following condition: ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...

Basic inspection
Diagnosis and repair workflow Workflow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.SYMPTOM CHECK Verify symptoms. ...

© 2014-2025 Copyright www.nisentra.com